Cables of CommScope Inc.

Courtesy of my company CommScope Inc. Of North Carolina, USA, I have installed new „Cell Reach ®“ coaxial cables in the dish. How easy the installation and handling is can be seen on the following pictures. Cable is smooth-wall (non-corrugated) and has excellent SWR electrical parameters!!!! Tested on 432 MHz with 1,5kW RF power and 1296 MHz with 600W RF power. By the ANRITSU site-master to the real impedance it measured SWR better than -31dB !!! If you are working in wireless or in the 50ohm RF business let me know and I can organize a meeting with our engineers. My responsibility is in the Broadband division with 75 ohm CATV trunk and drop cables or with Fiber Optic cables.

[Click to enlarge image] [Click to enlarge image] [Click to enlarge image] [Click to enlarge image] [Click to enlarge image] [Click to enlarge image]

First, easy to cut the cable

With the proper tool coring foam from the cable, strip the  PE jacket and cut the Cu outer conductor

After coring

[Click to enlarge image]

[Click to enlarge image]

[Click to enlarge image]

[Click to enlarge image]

[Click to enlarge image]

[Click to enlarge image]

Thanks to ACT you can easily clean the inner conductor. See www.commscope.com

Ready !!!

Connector including special plastic ring, which transforms the empty space in cable back to 50ohm impedance!!!

Installed connector.

[Click to enlarge image]

[Click to enlarge image]

[Click to enlarge image]

[Click to enlarge image]

TX port 1,5kW !!! 7/8"connector

From LNA Box RX port N-connector

Flexi-jumpers

In the mast before isolation by heat shrink tubes

CommScope - 50 ohm wireless catalogue

Connector for CR1070

CR1070 coring tools

All other about



Back to home page